Instruction manual

OPERATING INSTRUCTIONS
Connecting the power supply
Insert the AC power cord plug into the mains socket with power source 230V AC ~
50Hz. The unit is in standby mode and the clock starts to run.
Clock setting
When the unit is on, press STANDBY/ ON button to standby mode.
Set the clock
1. Press and hold CLOCK button on the remote
control for one second and “Hour digit” will flash.
Note: You can also press and hold SOURCE
button on the unit for one second.
2. Press VOLUME + / - buttons to set hour.
3. Press CLOCK button to confirm and the “Minute
digit” will flash.
4. Press VOLUME + / - buttons to set minute.
5. Press CLOCK button again to confirm the time
setting.
Select 24 or 12 Hour clock display
The 24 Hour clock display is the default setting. In standby mode, you can press
CLOCK button on the remote control to select the 12 Hour clock display and “AM” or
“PM” will be indicated in the display. Press CLOCK button again to select the 24
Hour clock display.
Note: You can also press SOURCE button on the unit for selection.
GB -5-