User Manual

Page 3 of 12
P/N 595284-01 Rev A 9/13
WARNING
WHEN MOUNTING THE QUEUE INTERFACE
ACCESSORY, SECURE THE ENTIRE LENGTH
OF THE POWER SUPPLY CORD OR WIRING
SO IT DOES NOT CAUSE A TRIPPING
OR ENTANGLEMENT HAZARD. PROTECT
THE CORD OR WIRING FROM EDGES OR
CORNERS THAT MAY CAUSE IT TO FRAY
OVER TIME. FAILURE TO PROPERLY SECURE
THE POWER SUPPLY CORD OR WIRING MAY
RESULT IN SERIOUS INJURY OR DEATH.
CONNECT THE ANTENNA
WARNING
WHEN INSTALLING THE QUEUE INTERFACE
ACCESSORY, USE ONLY THE ANTENNA
PROVIDED. USE OF ANY OTHER ANTENNA
WILL VOID THE FCC APPROVAL AND MAY
REDUCE THE PERFORMANCE OF THE
EQUIPMENT WHICH MAY RESULT IN SERIOUS
INJURY OR DEATH.
5. Align the pins in the connector with the socket and thread the collar on until snug.
Use no tools to tighten.
6. All wiring must be secured and must not provide a hazard to tripping or entangle-
ment in the chosen location. All wiring must be protected to prevent abrasion or
other damage.
7. Install the 2.4 GHZ Antenna, SCOTT P/N 31002537 by threading it onto the
antenna connector as shown in FIGURE X. Antenna should be nger tight. Use
no tools to tighten.
8. When the QUEUE Interface Accessory is connected to power, use the power
button to activate the unit and test it according to the REGULAR OPERATIONAL
INSPECTION section of this instruction.
ALIGN PINS --
THREAD IN COLLAR