User's Manual

Page 7 of 36
P/N 595289-01 Rev B 5/15
DATA LOGGING FEATURE
Respirators equipped with a SCOTT SEMS II distress alarm integrated PASS device
are compliant to NFPA 1982, 2013 Edition. The PASS device includes on-board
electronics which maintain a running log of event data including start-up, shut-down,
and PASS activation. The SCOTT DATA LOGGER Computer Interface is required
to access the information. Instructions for downloading the data log are SCOTT P/N
595123-01 and are included with the computer interface.
RETROFITTED UNITS
Installation of the SCOTT SEMS II Personal Distress Alarm requires some disassem-
bly of the respirator and should only be performed by an authorized service center.
Respirators already equipped with an approved SCOTT X3 Distress Alarm integrated
PASS device may be retrotted with the SEMS II Accountability System Control Con-
sole. However, if the PAK-TRACKER Transmitter was NOT enabled on the original X3
Distress Alarm, this will have to be enabled by a SCOTT Authorized Service Center
to receive the full functionality described in these instructions.
Contact SCOTT Safety, Monroe, NC at 1-800-247-7257 for complete details.
Report any operational malfunctions of the PASS function of this device to the
certication agency Safety Equipment Institute (SEI), 1307 Dolley Madison Blvd.
Suite 3A, McLean, VA 22101, [phone], FAX [phone].
QUESTIONS OR CONCERNS
If you have any questions or concerns regarding use of this equipment, contact your
authorized SCOTT distributor, or contact SCOTT at 1-800-247-7257 (or 704-291-8300
outside the continental United States) or visit our web site at www.scottsafety.com.