Installation and User Manual

UF424 / UN324 Installation and User Manual
August 2017
5
Placement
The location of the equipment should be selected
with care. Consideration should be given to allow
adequate space for air cooled models to breathe.
The ice machine is not designed for outdoor
use. It must be installed indoors, in a controlled
environment. The air and water temperatures
must not exceed rated limits.
Scotsman assumes no liability or responsibility of
any kind from products manufactured by Scots-
man that have been altered in any way, including
the use of any part and/or other components not
specically approved by Scotsman.
Scotsman reserves the right to make design
changes and/or improvements at any time.
Specications and design are subject to change
without notice.
Airow on air cooled models:
Intake from the right grill
Exhaust from the left grill
Do not install where this air ow is blocked.
The power outlet should be located within the
length of the supplied power cord. If legs will be
used, allow space for the total cabinet height.
Air cooled models in a small room will require
ventilation to exhaust heat from the condenser.
The condenser fan and motor will generate some
noise while the machine is running. Noise sen-
sitive areas should consider water cooled equip-
ment or locate the machine where the noise from
ice making will not objectionable.
Unpack
1. Separate the carton from the shipping
pallet
2. Inspect for any hidden shipping damage. If
any is found, retain carton and notify carrier
for potential claim. Shipping damage is not
covered by warranty.
Caution: Tip Over hazard to prevent injury or
damage to the machine please use caution when
lifting the unit. It will easily tips to the rear.
3. Remove bolts holding machine to pallet.
4. Install the legs. The legs are to be screwed
into the same holes the shipping bolts were
removed.
5. Remove the protective plastic covering the
panels. The longer it is left on the panel, the
more difcult it will be to remove it.
Spacing:
No additional spacing is required at the top or
sides. However, suggested minimum side clear-
ance for the installation is 1/8’’ or 3.2 mm and
suggested minimum top clearance is 1/4” or 6.4
mm.
The machine may be installed with 0 clearance at
the back. Do not block louvers at the front of the
cabinet.
Pre Installation:
Water supplied to the ice machine should be
ltered. Install a lter system that lters out
suspended solids. It may be necessary to add a
coarse pre-lter ahead of the ne lter.
Inspect the place where the ice machine is to be
installed. Check for:
• Space for the cabinet
• Water Supply
• Drain Availability
• Electrical Power Supply
DO NOT USE EXTENSION CORDS.
The building drain inlet must be lower than the
drain outlets at the back of the ice machine.
The water supply must have a hand shut off valve
accessible when the unit is installed.