Service manual

FOR THE INSTALLER: Specifications
This ice maker-dispenser is designed to be
mounted on a machine stand, or a countertop, or
using wall mounting kit KWB3, hung from a wall.
The sink may be retained, or removed and the
optional longer splash panel (KSP2) installed in
place of the original. Instructions for each kit are
included in this service manual.
Before beginning the installation, check that all the
materials and kits required are available at the
installation location.
SPECIFICATIONS
+ Minimum Circuit Ampacity is used to figure wire size and type per National Electric Code.
TDE650AE-1A
TDE650WE-1A
TDE650AE-6A
TDE650WE-6A
TDE550AE-1A
TDE550WE-1A
TDE550AE-6A
TDE550WE-6A
48.5 x 26 x 22.5
same
same
same
41 x 26 x 22.5
same
same
same
NUGGET
same
same
same
same
same
same
same
Air
Water
Air
Water
Air
Water
Air
Water
115/60/1
115/60/1
230/50/1
230/50/1
115/60/1
115/60/1
230/50/1
230/50/1
19.3
17.8
n/a
n/a
19.3
17.8
n/a
n/a
25
20
n/a
n/a
25
20
n/a
n/a
Maximum
Fuse
Size
Minimum
Circuit
Ampacity+
Basic
Electrical
Condenser
Type
Ice
Type
Dimensions
(w/o stand)
H" x W" x D"
Model Number Refrigerant
Charge
(R-404A)
24 ounces
18 ounces
24 ounces
18 ounces
24 ounces
10 ounces
24 ounces
10 ounces
14.06"
1.88"dia
20.5"
22.5"
2.56"
Optional for water and
drain lines
Serial Number Plate
inside on upper base
ELECTRICAL JUNCTION BOX
3/8" FPT
condenser
Water Inlet
(Water Cooled)
1/2" FPT
Cond. Drain
(Water Cooled)
3/4" FPT
Drain
12.27"
1.12"
3.12"
5.12"
6.43"
4.5"
3.54"
3/8" Flare
Potable Water Inlet
NAMEPLATE
on side panel
TDE550 & TDE650
August 1999
Page 2