Installation and User's Manual for Residential Ice Machine Models SCCG30 and SCCP30
SCCG30 & SCCP30 User Manual Introduction: This ice machine is the result of Scotsman’s decades of experience in the design and manufacturing of both commercial and residential ice machines. This manual includes the information needed to install, start up and maintain the ice machine. Note any Caution or Warning indicators, as they provide notice of potential hazards. Keep this manual for future reference. Table of Contents Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
SCCG30 & SCCP30 User Manual Specifications This ice machine is designed to be used indoors, in Options: a controlled environment. Use outside of the listed limitations is misuse and will void the warranty. Door Panel kits:Finished door panels are available from Scotsman for attachment to the machine, or a Air temperature limits custom panel can be made. The ice machine will operate adequately within the limits, but functions best in temperatures between 70 and 80 degrees F.
SCCG30 & SCCP30 User Manual Cabinet Layout FLOOR DRAIN ACCESS HOLE 3 7/8" 20 3/8" 22" .75 SHEET METAL DOOR FRONT .63 MIN. CABINET DOOR 14 7/8" 29 1/4" 33 3/8" MIN. 34 3/8" MAX. DRAIN FLEXIBLE TUBING 3/8 I.D. PUMP MODEL (INCLUDED) 5/8 I.D.
SCCG30 & SCCP30 User Manual Air flow The machine takes in room temperature air at the lower right front and discharges warm air from the lower left front. Restricting the airflow will adversely affect the ability of the ice machine to make ice. Warm Air Out Air Intake Scotsman Ice Systems are designed and manufactured with the highest regard for safety and performance. They meet or exceed the standards of agencies like U.L.
SCCG30 & SCCP30 User Manual Water Quality: All water, including potable water supplied by municipalities, contains some impurities or minerals. Water absorbs impurities from the air as rain and/or as it flows through the ground. Some of the impurities are solid particles, these are known as suspended solids, and a fine particle filter will remove them. Other impurities are chemically bonded to the water molecules, and cannot be filtered out, these are called dissolved solids.
SCCG30 & SCCP30 User Manual Door Panel The ice machine is supplied without a conventional door covering so it can be decorated to the user’s preference. Scotsman offers several coverings including white, black and stainless steel. In addition, a custom built panel can be placed onto the door. Custom Panel Door Panel Attachment See instructions in information packet to create and attach a custom panel: A custom panel of wood or other material not exceeding 15 lb can be attached to the door.
SCCG30 & SCCP30 User Manual Door Panel Attachment Use Upper Hole at the Top Scotsman Door Panel Gasket Machine Screw Hole Plug Use Lower Hole at the Bottom Cover November 2009 Page 8
SCCG30 & SCCP30 User Manual Door swing change Note: Prior models had separate hinge brackets and different directions to change swing. 4. Remove hole plugs or screws from unit's new hinge locations, set aside. Moving the hinges allows the door to open from either the left or right side. Change swing before attaching door panel. 5. Move screws loosened in step 1 to opposite location. 6. Install screws or plugs removed in step 4 to the unit's original hinge location to fill the holes. To change: 1.
SCCG30 & SCCP30 User Manual Water Water Supply, all models: The recommended water supply tubing is ¼ inch OD copper. Stainless steel flex or reinforced PVC tube may also be used. Install an easily accessible shut-off valve between the supply and the unit. This shut-off valve should not be installed behind the unit. Note: Do NOT connect water to tubing in the back of the unit. Water supply connects in the front. Drains Note: Do not use self-piercing type valves.
SCCG30 & SCCP30 User Manual Gravity Drain Caution: Restrictions in the drain system to the machine will cause water to back up into the ice storage bin and melt the ice. Gravity drain tubing must be vented, have no kinks and slope to the building drain. Air gaps are typically required by local code. 5. Cut an 8” piece of 5/8” ID X 7/8” OD tygon (clear plastic) tubing. Slide one end of the tube onto the outlet of the barbed connector and secure with a clamp.
SCCG30 & SCCP30 User Manual Electrical The ice machine is supplied with a power cord. Do not remove the grounding pin from the cord’s plug. Do not use extension cords. Follow all codes. Connect the machine to its own 115 volt, 15 amp circuit. Initial Start Up 1. If the electrical outlet for the ice maker is behind the unit, plug in the unit. 3. Switch the on/off switch to On. 2. Position the unit in the installation opening. 3. Turn on the water supply.
SCCG30 & SCCP30 User Manual Use No special instructions are needed for use. Just Maintenance take as much ice as you need, the machine will replace it. A scoop is provided, and it can be stored There are 5 things to keep clean: in the machine using the loop of tubing on the right side as a holder. 1. The outside cabinet & door. What shouldn’t be done? 2. The ice storage bin. Never keep anything in the ice storage bin that is 3. The condenser.
SCCG30 & SCCP30 User Manual How to clean the condenser. The condenser is like the radiator on a car, it has fins and tubes that can become clogged. To clean: How to clean the ice making system. 1. Scoop out all of the ice, either discard it or save it in a ice chest or cooler. 1. Remove the kickplate. 2. Locate the condenser surface. 3. Vacuum the surface, removing all dust and lint. 2.
SCCG30 & SCCP30 User Manual What to do before calling for service Ice cubes are incompletely formed • Clean the ice making system Low capacity • Check for restricted drain or standing water in the bin • Clean the air cooled condenser fins No ice • Check on-off switch • Check electrical breaker • Check water supply Erratic drain pump operation (pump models only) • Clean and sanitize bin.
SCOTSMAN ICE SYSTEMS 101 Corporate Woods Parkway Vernon Hills, IL 60061 800-726-8762 www.scotsman-ice.com 17-3191-01 Rev.
