Service manual

SENSOR MAINTENANCE
1. The bin control uses devices that sense light,
therefore they must be kept clean enough so that
they can “see”. At least twice a year, remove the
bin control sensors from the grommets in the ice
chute, and wipe them clean.
2. The ice machine senses water level by a probe
located in the water reservoir. At least twice a year,
the probe should be removed from the reservoir,
and the tip wiped clean of mineral build-up.
NDE554 & NDE654
March 2000
Page 18
BIN CONTROL
SENSOR
BIN TOP
BIN CONTROL
SENSOR
Moving Parts Hazard.
Disconnect electrical
power to the icemaker -
dispenser before
beginning.
Clean the Probe's Tip with ice
machine cleaner and a clean,
soft cloth.
3. Air Cooled Models: Check the air cooled
condenser for lint, dirt or grease build-up. Clean
with vacuum or soft brush until light can be seen
thru the fins.