Service manual

Repair Procedures: The Auger
Turn off the water to the machine, and unclip the
evaporator drain hose, pull it down and drain the
evaporator into the bin or a container.
1. Remove the the top panel.
2. Remove ice chute cover.
3. Unscrew ice sweep.
4. Remove ice chute body.
5. The auger and breaker/bearing may now be
removed as an assembly.
•
a. Unscrew 4 allen head cap screws holding
breaker to evaporator.
•
b. Lift up on breaker and remove auger from
evaporator.
Note: If the auger is stuck, the breaker must be
removed from the auger.
The breaker may be removed from the auger and
evaporator without disturbing the auger.
•
a. Unscrew breaker cover from breaker (left
hand threads)
•
b. Unscrew auger stud from top of auger.
•
c. Unscrew 4 allen head cap screws holding
breaker to evaporator.
•
d. Lift up & remove breaker from evaporator.
•
e. If the auger will not lift up use a slide
hammer type puller to pull on the auger at
the threaded hole. The size of that hole is
5/8"-18.
Inspect the auger, see the next page.
September 2009
Page 46
N0422, F0522, N0622, F0822, N0922, F1222, N1322, F1522
Air, Water or Remote Service Manual
Ice Sweep Removed
Remove allen head cap screws