Service manual

Component Indicator Lights
The controller has six lights to indicate component
operation:
Bin Eyes Blocked
•
This light is ON when the photo-electric ice
sensors have been blocked by ice.
Water Present
•
This light is ON when the water sensor has
water touching it.
Comp
•
This light is ON when the compressor is
operating.
Water Dispense
•
Not used on this model.
Auger
• This light is ON when the auger motor is
operating.
Ice Dispense
•
Not used this model.
Control Button Use
Recall diagnostic code:
•
Hold off button in for 3 seconds. Release.
•
Press and release the Clean button to cycle
through each of the last 10 error codes from
most recent to oldest.
Clear diagnostic code:
•
Hold Clean and Off buttons in for 3 seconds
to clear all prior codes.
Reset control:
•
Depress and release Off, then depress and
release On
Start Test Mode:
•
Hold Off button in for 3 seconds. Release.
•
Hold Clean button in for 3 seconds. Release.
Lock / Unlock control:
•
Hold On button in for 3 seconds, keep
holding then press and release Off twice.
September 2009
Page 17
N0422, F0522, N0622, F0822, N0922, F1222, N1322, F1522
Air, Water or Remote Service Manual