Installation and Manual

Ice Storage Bin Removal
The ice storage bin is removable to allow access to
the refrigeration system for service.
1. Remove front louvers. Remove left then right.
2. If the machine is in an ice making mode, push
and release the Manual Harvest button to release
any ice that might be on the evaporator.
3. Push and hold the controller's Off button to shut
the machine off.
4. Remove all ice from the bin.
5. Disconnect electrical power.
6. Remove door (open about 1.5" and pull bottom
out).
7. Remove the top panel, there are two fasteners
under the front corners of the top. Back them out
and lift the top up, push back slightly and lift panel
up and off the machine..
8. Disconnect the drain tube from the bin drain
fitting.
9. Remove two bolts from the bottom of the bin,
one on the left and one on the right.
10. Remove bolt from the back wall of the bin.
11. Pull the bin forward and off the chassis.
May 2008
Page 7
CU1526, CU2026, CU3030
User Manual
Remove
bolt to
release bin
Remove bolt
to release bin
Disconnect
hose before
moving bin.