Installation and Manual

Model Number Description
Example:
•
CU2026SA-1A
•
C= cuber
•
U=under the counter type
•
20= nominal ice capacity in 10s of pounds
•
26= nominal width of cabinet
•
S= Cube size. S=small or half dice cube.
M=medium or full dice cube
•
A=Condenser type. A=air cooled. W=water
cooled
•
-1=115 60 Hz, -32 = 230 volt, 60 Hz
•
A=Series revision code. A=first series
Note: In some areas of this manual model numbers
may include only the first six characters of the
model number, meaning that the cube size,
condenser type and voltage differences are not
critical to the information listed there.
Product Description & Electrical Requirements
Scotsman ice systems are designed and
manufactured with the highest regard for safety
and performance.
Scotsman assumes no liability of responsibility of
any kind for products manufactured by Scotsman
that have been altered in any way, including the
use of any part and/or other components not
specifically approved by Scotsman.
Scotsman reserves the right to make design
changes and/or improvements at any time.
Specifications and design are subject to change
without notice.
May 2008
Page 3
CU1526, CU2026, CU3030
User Manual
Dimensions
w" x d" x h"**
(without legs)
Model
Electrical
volts/Hz/phase
Condenser
Total Load
Amps
Maximum
Fuse Size*
26.62 x 27.5 x 33
CU1526SA-1 115/60/1 Air 7.7 15
CU1526SW-1 115/60/1 Water 7.7 15
26.62 x 27.5 x 33
CU2026SA-1 115/60/1 Air 7.2 15
CU2026SW-1 115/60/1 Water 7.2 15
CU2026SA-32 208-230/60/1 Air 3.7 15
CU2026SW-32 208-230/60/1 Water 2.96 15
30.62 x 30 x 33
CU3030SA-1 115/60/1 Air 10.4 15
CU3030SW-1 115/60/1 Water 10.4 15
CU3030SA-32 208-230/60/1 Air 5.54 15
CU3030SW-32 208-230/60/1 Water 4.48 15
Table notes: Height is without legs. Medium cube models have the same electrical characteristics as
Small. Series revision code omitted. * Or HACR type circuit breakers.
** If not using legs, add .25" for screws below base. Legs add 6 to 6.75 inches, but not the 1/4 inch for
the screws. Use of floor mounting kit adds about a half inch.