MSDS

MATERIAL SAFETY DATA SHEET Scotchgard™ Outdoor Water Shield (5020, 5019) 07/17/12
_________________________________________________________________________________________________
Page 4 of 9
Refer to other sections of this MSDS for information regarding physical and health hazards, respiratory protection, ventilation and
personal protective equipment. Evacuate unprotected and untrained personnel from the hazard area. The spill should be cleaned up by
qualified personnel. Ventilate the area. WARNING ! A motor could be an ignition source and could cause flammable gases or vapors in
the spill area to burn or explode. If it can be done safely, place the leaking containers in an exhaust hood or well- ventilated
area.WARNING ! To avoid problems with pressure buildup, slowly leaking pressurized aerosol cans should not be placed in sealed
containers. For large spill, or spills in confined spaces, provide mechanical ventilation to disperse or exhaust vapors, in accordance
with good industrial hygiene practice. Warning! A motor could be an ignition source and could cause flammable gases or vapors in the
spill area to burn or explode.
6.2. Environmental precautions
Dispose of collected material as soon as possible.
Clean-up methods
Contain spill, using absorbent if necessary. Collect spilled material with non-sparking tools. Clean up residue. Place depressurized cans
and clean up wastes in a metal container approved for transportation. Seal the container.
In the event of a release of this material, the user should determine if the release qualifies as reportable according to local,
state, and federal regulations.
SECTION 7: HANDLING AND STORAGE
7.1 HANDLING
Ground containers securely when transferring contents. Wear low static or properly grounded shoes. Do not spray near flames or
sources of ignition. Aerosol container contains flammable gas under pressure. Do not pierce or burn container, even after use. No
smoking while handling this material. Keep away from heat, sparks, open flame, pilot lights and other sources of ignition. Avoid
breathing of vapors, mists or spray. Avoid skin contact. Avoid eye contact with vapors, mists, or spray. Avoid contact with oxidizing
agents.
7.2 STORAGE
Store away from heat. Store out of direct sunlight. Store away from oxidizing agents. Do not store containers on their sides.
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
8.1 ENGINEERING CONTROLS
Do not use in a confined area or areas with little or no air movement. Use general dilution ventilation and/or local exhaust ventilation to
control airborne exposures to below Occupational Exposure Limits and/or control mist, vapor, or spray. If ventilation is not adequate,
use respiratory protection equipment.
8.2 PERSONAL PROTECTIVE EQUIPMENT (PPE)
8.2.1 Eye/Face Protection
Avoid eye contact with vapors, mists, or spray.
The following eye protection(s) are recommended: Safety Glasses with side shields
.
8.2.2 Skin Protection
Avoid skin contact.