Use and Care Manual

3M and Command are trademarks of 3M.
© 3M 2012. All rights reserved.
A ly Decorative Project:
Steps (continued):
Repeat step 7, linking each tag
board unit to another using the
lengths of string. Assemble 5 tag
board units per strand. You should
end with 6 strands, with some
extra left over. Be sure to alternate
Mylar and cellophane wrap and
alternate tag board colors to
create a pleasing pattern.
Use Scotch® Magic™
Tape to attach the
tag board disks to the
center of each length
of string between
every two units.
Use Scotch® Magic™
Tape to attach the nal 6
pieces of string in loops
to the top tag board unit
on each strand.
Ax 6 Command™ Clear
Small Hooks (following all
package instructions) to
tops of window frames.
Hang each strand on the
hooks. Enjoy!
In a well-ventilated,
masked o area, spray
one side of a tag board
donut. Move the donut
to a clean sheet of
paper and center the
Mylar disk over the
donut. Place and press
to secure the bond.
Place the tip of a
length of string onto
the edge of the
adhesive-sprayed
donut.
Center a second
tag board donut on
top of the prepared
string/Mylar/tag
board unit and press
to secure the bond.