Owner's Manual

~
SCC,SC?
11-.
SAHD675B
AFTERMARKETSPEAKERADAPTERS
FOR
SELECT
HARLEY-DAVIDSON
2006-2013
FLHX STREET GLIDE,
1996-2013
FLHT
ELECTRA GLIDE &
1998-UP
FLTR ROAD GLIDE
MODELS
PARTS INCLUDED:
(2)
Speaker adapters
(2)
Gaskets
(6)
Mounting screws
SCREWS (x6)
GASKET (x2)
INTRODUCTION/PRELIMINARY
These Scosche all-in-one speaker adapter-spacers allow you
to
install
most
5.25"
and
6.5"
aftermarket
speakers in select Harley Davidson motorcycles. These premium adapters
mount
on
to
the
existing
factory locations
in
the
fairing with
no
modifications required. Refer
to
the
steps
in this manual
for
your
particular model.
CAUTION
DISCONNECT YOUR CYCLE'S NEGATIVE BATTERY TERMINAL BEFORE THE INSTALLATION TO
HELP PREVENT ELECTRICAL DAMAGE. WE RECOMMEND THE USE OF A VOLT/OHM METER
OVER A TEST LIGHT TO CHECK WIRING. A TEST LIGHT OR GROUNDED WIRE PROBE CAN
CAUSE DAMAGE TO THE CYCLE'S COMPUTER AND/OR DIAGNOSTIC SYSTEMS.
PREPARATION:
Work on a clear
level
surface
Place bike
on
kickstand with wheel tilted toward the leaning direction
Use felt or soft cloths to cover and protect painted surfaces
TOOLS REQUIRED (not included):
T-25
Torx drive
T-27
Torx
drive
7/16" socket or box wrench
(Road
Glide models only}
Wire
strippers/cutters
3/16"
or
5mm hex drive
LIABILITY
DISCLAIMER
This manual is based on carefully documented research. Absolute accuracy is attempted, but not guaranteed.
Use the manual as a reference guide as your bike may differ. Scosche Industries, Inc. cannot be held responsible
for
inconsistencies that may occur due
to
vehicle manufacturing changes
or
options,
or
damage that may occur
to
the vehicle
during
the
installation
of
components while using this booklet.
If
you
have
any
further
questions,
call
our
toll free
technical
help
line at:
1-800-621-3695x3
©2017 SCOSCHE INDUSTRIES, INC.
SI
SAHD6758
01
/
18

Summary of content (4 pages)