manual
MOUNTING THE RADIO
DOUBLE DIN-ISO & 2 DIN-ISO MOUNT
(DIN-E Radi0 with Side Mounting Holes)
1. Snap the DIN-ISO side mounting brackets to the back of the mounting
panel (1 left and 1 right). Use supplied hardware to bolt them to the
back of the kit panel.
2. Snap the DIN-ISO trim ring into the radio opening.
3. Load the radio from the REAR of the mounting panel until the
nose piece of the radio comes through the front of the kit.
4. Use the 5mm screws to secure the radio from the sides.
CAUTION:
REAR SUPPORT AVAILABLE
SEPARATELY. REAR
SUPPORTING THE RADIO
ADDS TO THE INSTALLATION’S
STRUCTURAL INTEGRITY.
VARIOUS REAR
SUPORTS (NOT
INCLUDED)
VEHICLE DISASSEMBLY
2007-Up Kia Optima
RADIO REMOVAL:
1. Using a panel removal tool, start from the steering column and unsnap the dash panel surrounding
the factory radio.
2. Use a Phillips Head Screwdriver to remove (4) screws securing the factory radio.
3. Lift away, disconnect and remove.
2
3
2005
1
/
2
-Up Kia Spectra
2005-Up Kia Spectra 5
RADIO REMOVAL:
1. Using a panel removal tool, remove the dash panel surrounding the radio. Disconnect and remove.
2. Extract (4) Phillips Head Screws securing the radio to the dash. Disconnect and remove.
2007 Hyundai Entourage
2006-Up Kia Sedona
RADIO REMOVAL:
1. Using a panel removal tool, extract the bezel
surrounding the shifter.
2. Using a panel removal tool, unsnap the dash
bezel surrounding the radio.
3. Extract (1) Phillips Head Screw securing EACH
air vent panel.
4. Using a panel removal tool, unsnap and remove
air vent panels.
5. Extract (4) Phillips Head Screws securing factory
A/C control panel.
6. Extract (4) Phillips Head Screws securing radio to
dash.
USE SHADED BRACKETS
USE SHADED BRACKETS
USE SHADED BRACKETS