Owner's Manual
Table Of Contents
- Installation Instructions
- Parts Supplied
- Introduction
- Factory Stereo Removal
- Dash Modification
- Stereo Assembly / Mounting
- Steering Wheel Controls
- Wiring Diagram
- Wire Color Codes
- Vehicle Startup
- UAC Vehicle Door Locks
- Climate & Convenience Controls
- Menu Navigation
- Vehicle Settings Chart
- Interface Settings Chart
- Language Selection Settings Chart
- Version Setting Chart
- Scans of Packaging
DOUBLE DIN ISO INSTALLATION
Step 1
Mount the 7147 and 7148 left and right
brackets to the sides of the aftermarket
stereo using the screws supplied
with the stereo.
Step 2 (Double DIN)
Connect and mount the stereo into
the vehicle dash cavity
Step 3 ((Double DIN)
Mount the main kit panel into cavity over the
mounted stereo.
4
STEREO ASSEMBLY / MOUNTING
HAZARD WARNING FLASHERS
Press the Hazard button (page 2, #2) to activate
flashing signal lamps (flash on and off). This warns
others that you are having trouble. Press again to turn
the flashers off. (Located top center of face panel).
7147 LEFT
MOUNTING
BRACKET
7148 RIGHT
MOUNTING
BRACKET
1. Seek/Track UP (click SRC button upward)
2. Short Press= Pick Up /
Long Press= Voice Recognition/Siri/Android Auto
3. Short Press= Hang Up / Long Press= Mute
4. Seek/Track DOWN (click SRC button downward)
5. SRC (Source) - Press in to change source
6. Volume DOWN
7. Volume UP
NOTE: When the optional GMOSM1 module is installed, Volume UP/
Volume Down buttons can be used in order to adjust the volume level
of the On-Star call.
STEERING WHEEL CONTROL OPERATION
(WHEN VEHICLE IS EQUIPPED)
Steering Wheel Control layout
©2017 SCOSCHE INDUSTRIES, INC.
ITCGM01B 05/17
STEERING WHEEL CONTROLS