Owner's Manual

INSTALLATION
GUIDE
Panel
Preparation
Step
12
Panel
Preparation
Place
the drive train/
ignition
control
trim into the
(7773) face
panel
Step
13
Panel
Preparation
• Place the
OEM
drive train/
ignition
control
buttons (retained in
Step
11) into the trim from Step
12.
• Next
Place
the three provided
PCB
spacers Indicated by arrows on top
of
button
controls.
Step
14
Panel
Preparation
Panel
&
Trim
Place
the rubber pad from the
OEM
drive-train
controls
onto the back
of
the
buttons being cautious not to knock over the spacers placed
on previous step.
Step
15
Panel
Preparation
Carefully align
the circuit board over
the rubber pad, then continue to the
next step.
Close-Up
5
ITCFD05B 05/17
)