Owner's Manual

5
2000-05 Chevrolet Impala
RADIO REMOVAL:
1. Extract (2) 9/32" hex screws from above instrument panel.
2. Remove fuse panel cover and extract (1) 9/32" hex screw from behind.
3. Remove passenger side fuse cover and extract (1) 9/32" screw from behind.
4. Drop underdash covering using panel removal tool and extract (2) 9/32" screws from
behind.
5. Remove (1) 9/32" screw from left side trim, tilt wheel down, and pull away dash bezel,
disconnect and remove.
6. Remove (3) 9/32" screws securing the radio, disconnect and remove from dash.
2000-05 Chevrolet Monte Carlo
RADIO REMOVAL:
1. Extract (1) Phillips head screw from glove box.
2. Remove cylinder cover from around ignition keyhole.
3. Extract (2) Phillips head screw from beneath steering column plate, and remove cover.
4. Remove fuse access cover and remove (1) Phillips head screw from behind.
5. Adjust steering wheel column down and remove dash trim bezel. Disconnect hazard switch and remove
panel.
2001-03 Chevrolet Malibu
2004 Chevrolet Classic
RADIO REMOVAL:
1. Use a small flat blade or pick to remove ignition switch collar.
2. Using panel removal tool, pry out dash bezel, disconnect and remove.
3. Remove three (3) 7MM screws securing radio, disconnect and remove.
2004-UP Chevrolet SSR
RADIO REMOVAL:
1. Using a panel removal tool remove the aluminum trim that separates the dash.
2. Remove six (6) 7MM hex screws securing the dash panel.
3. Remove the dash by pulling towards you. Use caution when removing the dash around
the passenger’s air bag. Bend the sides of the passenger air bag cover to release the
passenger side of the dash.
4. Remove three (3) 7MM hex screws securing radio to the dash. Disconnect and remove the radio.
2002-03 Chevrolet S-10 Pickup
RADIO REMOVAL:
1. Turn ignition ON and shift vehicle into first if an automatic.
2. Extract (1) 9/
32
" screw from above gauge cluster.
3. Extract (5) 9/
32
" screws from unerdash pane; and remove.
4. Extract (2) 9/
32
" screws from bottom of dash bezel, and carefully pry out bezel.
CAUTION: WHEN YOU GO TO PULL BEZEL OVER HAZARD SWITCH BE VERY CAREFUL NOT TO BREAK
SWITCH. DISCONNECT AND REMOVE BEZEL.
5. Extract (3) 9/
32
" screws securing radio, disconnect, and remove.
2002-UP Chevrolet Trailblazer
RADIO REMOVAL:
1. Extract (2) Phillips screws from above instrument panel.
2. Extract (1) Phillips screw from under AC controls.
3. Extract (2) Phillips screws from lower dash panel above brake panel.
4. Carefully pull dash bezel off, disconnect and pull away.
5. Extract (2) 9/32" hex screws, disconnect and remove radio.