manual

Read pages 3-6
for kit assembly.
Read pages 3-6
for kit assembly.
Read pages 3-6
for kit assembly.
"A1" BRACKET USE
HOLE #1
"A1" SOPORTE USA
ABERTURA NO. 1
LEFT SIDE
LADO IZQUIERDA
RIGHT SIDE
LADO DERECHO
"B1" BRACKET
USE HOLE #2
"B1"
SOPORTE
USA
ABERTURA
NO. 2
FRONT OF KIT
FRENTE DE ESTUCHE
TRIM
BRACKET
CORTA EL
SOPORTE
"A2" BRACKET USE
HOLE #1
"A2" SOPORTE USA
ABERTURA NO. 1
"B2" BRACKET
USE HOLE #2
"B2" SOPORTE
USA ABERTURA NO. 4
"A1" BRACKET USE
HOLE #1
"A1" SOPORTE USA
ABERTURA NO. 1
LEFT SIDE
LADO IZQUIERDA
RIGHT SIDE
LADO DERECHO
"B1" BRACKET
USE HOLE #2
"B1" SOPORTE
USA ABERTURA
NO. 2
FRONT OF KIT
FRENTE DE ESTUCHE
TRIM
BRACKET
CORTA EL
SOPORTE
"D2" BRACKET USE
HOLE #1
"D2" SOPORTE USA
ABERTURA NO. 1
"B2" BRACKET
USE HOLE #2
"B2" SOPORTE
USA ABERTURA NO. 4
"A1" BRACKET USE HOLE #3
"A1" SOPORTE USA ABERTURA NO. 3
LEFT SIDE
LADO IZQUIERDA
RIGHT SIDE
LADO DERECHO
"A1" BRACKET USE HOLE #3
"A1" SOPORTE USA ABERTURA NO. 3
FRONT OF KIT
FRENTE DE ESTUCHE
"C2" BRACKET USE HOLE #3
"C2" SOPORTE USA ABERTURA NO. 3
"B2" BRACKET USE HOLE #3
"B2" SOPORTE USA ABERTURA NO. 3
7
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
1982-1996 Buick Century
RADIO REMOVAL:
1. Remove the four screws from under the top
edge of the instrument cluster trim piece.
2. Remove the three screws and the two 7mm hex screws from below the instrument cluster trim piece.
3. Remove the three screws and the rocker-switch trim to the right of the instrument cluster. Pull fi rmly to
remove the rocker-switch trim.
NOTE: For cars equipped with a
column mounted shift lever, position
the lever in low gear for additional
clearance.
4. Remove the instrument cluster
trim piece.
5. Remove the four screws from
the radio brackets, pull the radio
out of the cavity, then disconnect
the antenna, speaker leads
and all the electrical connections.
Remove the radio.
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
1985-90 Buick Electra/Park Avenue
1986-91 Buick Le Sabre
RADIO REMOVAL:
1. Carefully snap off the trim from around the air-conditioning controls.
2. Remove the four screws from behind the trim piece.
3. Slide the radio trim panel to the
left (driver’s side) of the car and
remove it.
4. Remove the four screws which
secure the radio to the dashboard,
slide the radio out of the cavity
and disconnect the antenna,
speaker leads and all the
electrical supply harnesses.
Remove the radio.
1984-87 Buick Regal
RADIO REMOVAL:
1. Remove the radio trim panel by carefully prying outward
evenly around the edges.
2. Remove the four screws securing the radio mounting bracket to the dash. Pull the assembly out of the
cavity to gain access to the wiring.
3. Disconnect the antenna and all the electrical connections, then remove the radio.
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.