manual

Read pages 3-6
for kit assembly.
FRONT OF KIT
FRENTE DE
ESTUCHE
"B1" BRACKET USE
HOLE #1
"B1" SOPORTE
USA ABERTURA NO. 1
"C2" BRACKET
USE HOLE #5
"C2" SOPORTE USA
ABERTURA NO. 5
RIGHT SIDE
LADO DERECHO
LEFT SIDE
LADO IZQUIERDA
TRIM BRACKET
CORTA EL SOPORTE
Read pages 3-6
for kit assembly.
FRONT OF KIT
FRENTE DE
ESTUCHE
"B1" BRACKET USE HOLE #2
"B1" SOPORTE USA ABERTURA
NO. 2
"A1" BRACKET USE HOLE #2
"A1" SOPORTE USA ABERTURA NO. 2
"C2" BRACKET USE HOLE #1
"C2" SOPORTE USA ABERTURA NO. 1
RIGHT SIDE
LADO DERECHO
LEFT SIDE
LADO IZQUIERDA
"D2" BRACKET USE HOLE #1
"D2" SOPORTE USA ABERTURA NO. 1
TRIM BRACKET
CORTA EL
SOPORTE
Read pages 3-6
for kit assembly.
"C1" BRACKET
USE HOLE #2
"C1" SOPORTE USA
ABERTURA NO. 2
"B1" BRACKET
USE HOLE #2
"B1" SOPORTE USA
ABERTURA NO. 2
FRONT OF KIT
FRENTE DE ESTUCHE
TOP
TOPE
28
1995-99 Pontiac Sunfi re/Convertible
RADIO REMOVAL:
1. Open glovebox then remove two screws along the right side
of the radio/heater trim bezel.
2. Carefully pull out on the right side of the radio/heater trim bezel and two
alignment pins will release on the
driver’s steering
column panel.
3. Remove radio/
heater trim bezel.
4. Extract two screws
holding radio, unplug
and remove.
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
1982-91 Pontiac 6000
RADIO REMOVAL:
1. Loosen the screw securing the radio trim panel
to the left side of the glove box.
2. Carefully pull the panel outward to relieve the clips retaining
the left side of the panel. Remove the trim panel.
3. Remove the four screws retaining the radio, and pull the radio out of the cavity.
4. Disconnect the antenna, speaker leads and all the electrical connections, then remove the radio.
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
1991-94 Saturn SC, SL, SL1, SL2
RADIO REMOVAL:
1. Using a panel removal
tool/screwdriver, carefully
pry outward on the dash
bezel to release the clips
and remove the bezel.
2. Extract the two screws securing
the radio to the dash. Pull the
unit out of the dash, unplug
the connectors and
remove the radio.
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.