manual

Read pages 3-6
for kit assembly.
FRONT OF KIT
FRENTE DE
ESTUCHE
"B1" BRACKET USE HOLE #1
"B1" SOPORTE USA ABERTURA NO. 1
"A1" BRACKET USE HOLE #2
"A1" SOPORTE USA ABERTURA NO. 2
RIGHT SIDE
LADO
DERECHO
LEFT SIDE
LADO
IZQUIERDA
Read pages 3-6
for kit assembly.
FRONT OF KIT
FRENTE DE
ESTUCHE
"B2" BRACKET USE HOLE #2
"B1" SOPORTE USA ABERTURA NO. 2
"A1" BRACKET USE HOLE #2
"A1" SOPORTE USA ABERTURA NO. 2
RIGHT SIDE
LADO
DERECHO
LEFT SIDE
LADO
IZQUIERDA
Read pages 3-6
for kit assembly.
BOTTOM
FONDO
CARRIAGE BOLT
PERNO DE PORTE
FLANGE NUT
TUERCO REBORDE
27
1997-99 Pontiac Grand Prix
RADIO REMOVAL:
1. Extract two panel fasteners from driver’s (left) side underdash cover.
2. Extract two 7mm hex screws from bottom edge of driver’s (left) side
lower dash panel and carefully pull out on the upper panel to release two panel clips.
Unplug and remove the dash piece.
3. Carefully pull out on the complete dash/radio/instrument bezel, unsnap, and unplu before removing.
4. Extract two 7mm screws holding the factory radio, unplug connectors and antenna to remove radio.
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
1994-96 Pontiac Grand Prix
RADIO REMOVAL:
1. Remove ash tray.
2. Extract two push pin style fasteners on the bottom side of the
radio/dash/bezel where it curves under the dash.
3. Carefully pry out on the dash trim to release two panel clips and remove the dash piece.
4. Extract two 7mm screws holding the factory radio, unplug connectors and antenna to remove radio.
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
1992-1993 Pontiac Grand Prix
RADIO REMOVAL:
1. Extract the two screws securing the glove box door
hinges and remove the door.
2. Extract the two screws securing the radio trim bezel on the passenger side.
3. Extract the three screws from the underside of the dash securing the under dash panel
below the steering column.
Disconnect all the connectors
and remove the panel.
4. Extract the two screws
securing the radio trim bezel
on the driver’s side and remove
the bezel.
5. Remove the two nuts from the
bottom of the radio cavity securing
the radio to the dash. Pull the radio
from the cavity, unplug the connectors
and remove the radio.
USE THE SUPPLIED CARRIAGE BOLTS & NUTS TO MOUNT THE KIT PANEL TO THE SUB-DASH.
Usa los pernos de portey tuercos proveidos para montar la tablera estuche al tablero-sub.