manual

Read pages 3-6
for kit assembly.
Read pages 3-6
for kit assembly.
FRONT OF KIT
FRENTE DE
ESTUCHE
"B1" BRACKET
USE HOLE #1
"B1" SOPORTE
USA ABERTURA
NO. 1
"A1" BRACKET USE HOLE #1
"A1" SOPORTE USA ABERTURA
NO. 1
"C2" BRACKET
USE HOLE #1
"C2" SOPORTE USA ABERTURA NO. 1
RIGHT SIDE
LADO DERECHO
LEFT SIDE
LADO IZQUIERDA
"D2"
BRACKET USE HOLE #1
"D2" SOPORTE USA ABERTURA NO. 1
FRONT
OF KIT
FRENTE DE
ESTUCHE
"B1" BRACKET
USE HOLE #1
"B1" SOPORTE USA ABERTURA
NO. 1
"C2" BRACKET
USE HOLE #5
"C2" SOPORTE USA
ABERTURA NO. 5
TRIM BRACKET
CORTA EL SOPORTE
RIGHT SIDE
LADO DERECHO
LEFT SIDE
LADO IZQUIERDA
TRIM
BRACKET
CORTA EL
SOPORTE
Read pages 3-6
for kit assembly.
TOP
TOPE
CARRIAGE BOLT
PERNO DE PORTE
FLANGE NUT
TUERCO REBORDE
Read pages 3-6
for kit assembly.
"G" BRACKET
SOPORTE "G"
"F" BRACKET
SOPORTE "F"
TOP
TOPE
26
1996-98 Pontiac Grand Am
RADIO REMOVAL:
1. Extract two screws from the dash bezel above instrument/gauges.
2. Extract two screws from back of deep
storage pocket below the radio.
3. Carefully pull out on the
instrument/radio panel to
release snap clips, unplug
switches and remove bezel.
4. Extract three 7mm screws
securing radio, unplug
connectors, antenna lead,
and remove radio.
1985-92 Pontiac Firebird
RADIO REMOVAL:
1. Carefully pull on the
edges of the radio
trim panel to release
the panel clips and
remove the panel.
2. Remove the four screws
which secure the radio
to the console.
3. Disconnect the
antenna, speaker leads
and all the electrical
connections, then
remove the radio.
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
1992-1995 Pontiac Grand Am
RADIO REMOVAL:
1. Extract the screw from the underside of the radio trim bezel.
2. Extract the fi ve screws from the upper glove box securing
the glove box assembly and remove the glove box.
3. Open up the lower glove box and extract the three
screws securing the radio trim bezel near the pin switch.
4. Extract the three screws from below the steering column that
secure the top of the driver's side lower dash.
5. Extract the fi ve screws securing the lower section
of the driver's side lower dash panel and remove the panel.
6. Extract the screw securing the radio trim bezel behind the driver's side lower dash panel.
7. Using a panel removal tool/screwdriver, carefully pry the
radio trim bezel outward to release and remove it.
8. Remove the two nuts from below the radio cavity securing the radio to the dash,
pull the radio from the cavity, unplug the leads and remove the radio.
SECURE THE KIT PANEL TO THE SUB-DASH USING THE SUPPLIED CARRIAGE NUTS AND BOLTS.
Asegura el panel estuche al tablero-sub usando los tuercos y pernos de porte.
1985-91 Pontiac Grand Am
RADIO REMOVAL:
1. Unsnap the front edge of the gearshift
trim piece from the center console.
2. Gently pull on the radio trim panel
to release the snaps and remove the trim.
3. Remove the two screws which
secure the radio and slide the radio out of the cavity.
4. Disconnect the antenna, speaker leads and
all the electrical connections, then remove the radio.
SECURE THE KIT PANEL TO THE SUB-DASH USING THE SUPPLIED CARRIAGE NUTS AND BOLTS.
Asegura el panel estuche al tablero-sub usando los tuercos y pernos de porte.