manual

LEFT SIDE
LADO IZQUIERDA
Read pages 3-6
for kit assembly.
CARRIAGE BOLT
PERNO DE PORTE
BOTTOM
FONDO
FLANGE NUT
TUERCO REBORDE
Read pages 3-6
for kit assembly.
FRONT OF KIT
FRENTE DE
ESTUCHE
RIGHT SIDE
LADO DERECHO
"A1" BRACKET USE HOLE #2
"A1" SOPORTE USA
ABERTURA NO. 2
"B1" BRACKET USE HOLE #2
"B1" SOPORTE USA ABERTURA NO. 2
Read pages 3-6
for kit assembly.
BREAK OFF TAB
ROMPE LA LENGUETA
"D1" BRACKET
USE HOLE #1
"D1" SOPORTE USA ABERTURA NO. 1
"C1" BRACKET
USE HOLE #5
"C1" SOPORTE
USA ABERTURA NO. 5
BOTTOM
FONDO
21
1992-95 Oldsmobile Achieva
RADIO REMOVAL:
1. Extract the two screws from the bottom of the dash
bezel, below the radio and above the console pocket,
securing it to the dash.
2. Extract the two screws above the instrument cluster.
3. Remove the two screws above the AC vent located in
the center of the dash.
4. Pull the dash bezel out away from the dash and using
a panel removal tool/screwdriver, carefully disconnect
the fastening clips securing the dash vents (the one in
the center and the one on the driver's side) to the bezel.
5. Disconnect all the connectors and slide the dash bezel
away from the dash towards the passenger side.
6. Extract the two 10mm bolts securing the radio to the dash, pull the
radio from the cavity, unplug all the connectors, and remove the radio.
SECURE THE KIT PANEL TO THE DASH USING THE SUPPLIED CARRIAGE BOLTS AND NUTS.
Asegure el panel estuche al tablero usando los pernos de porte y tuercos proveidos.
1997-99 Chevrolet Venture
1997-99 Oldsmobile Silhouette
1997-99 Pontiac Trans Sport
RADIO REMOVAL:
1. Open ashtray and extract one from lower right side of dash bezel.
2. Open 12V socket cover and extract one from lower left dash bezel.
3. Lift bottom of dash bezel out to allow top edge to unhook from under air vents, unplug lighter,
switches and remove dash.
4. Extract two 7mm hex head screws holding radio in, unplug connectors and remove radio.
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
1985-91 Oldsmobile Cutlass Calais
RADIO REMOVAL:
1. Open armrest and extract (2) Phillips head screws
from bottom of pocket.
2. Remove pocket and extract (2) 10mm bolts from
underneath. Lift and slide armrest towards rear of car.
3. Extract (2) 7mm/t-15 bolts from rear edge of gear
select lever trim panel. Remove ashtray (on center
console) and extract (1) 7mm/t-15 bolt from underneath.
4. Put car in low gear. Lift and slide center console
towards rear of car
5. Gently unsnap and remove radio trim bezel.
6. Extract (2) 7mm/T-15 Torx screws securing
radio to the dash, unplug wiring, antenna,
and remove radio.
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.