manual

Read pages 3-6
for kit assembly.
Read pages 3-6
for kit assembly.
RIGHT SIDE
LADO
DERECHO
LEFT SIDE
LADO
IZQUIERDA
FRONT OF KIT
FRENTE DE
ESTUCHE
"C1" BRACKET USE HOLE #2
"C1" SOPORTE USA ABERTURA NO. 3
"D1" BRACKET USE HOLE #2
"D1" SOPORTE USA ABERTURA NO. 2
Read pages 3-6
for kit assembly.
RIGHT SIDE
LADO DERECHO
LEFT SIDE
LADO IZQUIERDA
FRONT OF KIT
FRENTE DE
ESTUCHE
"A1" BRACKET
USE HOLE #2
"A1" SOPORTE USA
ABERTURA NO. 2
"B1" BRACKET
USE HOLE #3
"B1" SOPORTE USA
ABERTURA NO. 3
"B2" BRACKET USE HOLE #1
"B2" SOPORTE USA ABERTURA NO. 1
"C2" BRACKET USE HOLE #1
"C2" SOPORTE USA ABERTURA NO. 1
USE THE INDICATED BRACKETS AND HOLE LOCATIONS. SEE PAGE 4.
Usa los soportes y localizaciónes de aberturas indicadas. Vea la página 4.
2171 RIGHT
BRACKET
SOPORTE
DERECHO
2171
2171
LEFT
BRACKET
SOPORTE
IZQUIERDA
2171
USE HOLE #2
USA ABERTURA NO. 2
USE HOLE #2
USA ABERTURA NO. 2
USE HOLE #8
USA ABERTURA
NO. 8
USE HOLE #8
USA ABERTURA
NO. 8
17
1996-00 Chevrolet Express Van
1996-00 GMC Savannah
RADIO REMOVAL:
1. Carefully pull out on
dash instrument/
radio dash bezel to
release spring clips,
unplug connectors
and remove panel.
2. Compress the two plastic
side radio mounting clips,
slide radio out of dash, unplug connectors and remove radio.
1995-99 Chevrolet Lumina
1995-99 Chevrolet Monte Carlo
RADIO REMOVAL:
1. Remove the four
T-15 TORX screws
from the driver’s
lower knee bolster.
2. Pull on the radio dash
bezel to release the
spring clips and remove.
3. Extract the two 7 mm
screws from the radio,
unplug and remove
the radio.
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
1990-94 Chevrolet Lumina
RADIO REMOVAL:
1. Remove the two screws from the lower steering column trim piece
(below the column). Pull the panel down to access the bottom
portion of the dash trim.
2. Pull outward along the top and bottom portion of the trim panel. Release each vent's individual
spring clip.
3. Extract the four screws from the radio bracket.
4. Pull the unit out of the cavity. Disconnect the connectors and remove the unit.
NOTES: 1. Due to its rear support, you might need to use slight force to pull the radio free. 2. The factory
antenna uses a micro-size jack. We recommend Radio Shack’s GM antenna adaptor (Cat. number 12-1336).
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.