manual

Read pages 3-6
for kit assembly.
"B2"
BRACKET USE HOLE #1
"B2" SOPORTE USA ABERTURA NO. 1
"D1" BRACKET USE HOLE #2
"D1" SOPORTE USA
ABERTURA
NO. 2
RIGHT SIDE
LADO DERECHO
FRONT OF KIT
FRENTE DE
ESTUCHE
"A2" BRACKET USE HOLE #3
"A2" SOPORTE USA ABERTURA NO. 3
LEFT SIDE
LADO IZQUIERDA
"C1" BRACKET USE HOLE #4
"C1" SOPORTE USA
ABERTURA NO. 4
TRIM BRACKET
CORTA EL SOPORTE
Read pages 3-6
for kit assembly.
Read pages 3-6
for kit assembly.
Read pages 3-6
for kit assembly.
CARRIAGE BOLT
PERNO DE PORTE
BOTTOM
FONDO
FLANGE NUT
TUERCO REBORDE
2171 RIGHT
BRACKET
SOPORTE
DERECHO
2171
2171 LEFT BRACKET
SOPORTE IZQUIERDA
2171
USE HOLE #2
USA ABERTURA NO. 2
USE
HOLE #2
USA ABERTURA NO. 2
USE HOLE #8
USA ABERTURA
NO. 8
USE HOLE #8
USA ABERTURA
NO. 8
12
1990-95 Chevrolet Astro
1990-95 GMC Safari
RADIO REMOVAL:
1. Remove two screws from the underside of the center dash trim piece.
2. Carefully release the
spring clips securing
the center panel trim
piece (trim snaps off).
3. Pull the trim away from the dash,
disconnect the various electrical
connections, and remove the panel.
4. Extract the four screws
securing the radio to the
dash, two screws at each
side. Pull the radio out of
the cavity, and disconnect
the antenna and electrical
harnesses. Remove the radio.
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
1996-02 Chevrolet Astro Van
1996-02 GMC Safari Van
RADIO REMOVAL:
1. Extract (2) T-30 Torx bolts, one from each side of the top console
area and pop out top half of center console assembly.
2. Extract (2) 9/32" hex screws from the bottom edge of the driver's side under
dash panel and (1) screw from
left dash below defroster vent.
3. Carefully pry underdash panel
out to release, and use caution
when handling parking brake
release cable to release spring clips,
unplug connectors and remove panel.
4. Insert key into "on", adjust shifter
down (low gear), pull outward on
the instrument/radio panel to release clips, unplug switches & remove panel.
5. Push down on side tabs securing radio, slide out of dash, unplug & remove radio.
1985-89 Chevrolet Astro
1985-89 GMC Safari
RADIO REMOVAL:
1. Remove three screws from the top edge of the radio trim panel.
2. Remove two 10mm bolts from the lower edge of the trim panel
(inside glove box).
3. Pull the console trim towards the rear of the vehicle and remove
two 7mm bolts from behind the trim. Remove the radio trim panel.
4. Remove two screws from the bottom of the radio retainer bracket.
5. Carefully pull the radio out of the cavity. Disconnect the antenna,
speaker and all electrical connections, the remove the radio.
USE THE "E" BRACKETS ON THE BOTTOM LEFT AND BOTTOM RIGHT SIDE OF THE KIT.
Usa los soportes "E" abajo en los lados izquierda y derecha del estuche.
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS & DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
1991-96 Chevrolet Beretta
1991-96 Chevrolet Corsica
RADIO REMOVAL:
1. Remove the radio trim bezel by prying outward with a
panel removal tool/screwdriver releasing the snap clips
securing it to the dash.
2. Extract two screws securing the radio to the dash.
Pull the radio out of the cavity, unplug all connectors
and remove the radio.
USE THE INDICATED BRACKETS AND HOLE LOCATIONS. SEE PAGE 4.
Usa los soportes y localizaciónes de aberturas indicadas. Vea la página 4.