Installation instructions

15
1994-95 Chrysler Town & Country
1994-95 Dodge Caravan
1994-95 Plymouth Voyager
Radio Removal:
1. Using a panel removal tool carefully pry up on the dash panel at the base of the windshield (speaker
grille panel) to release the fastening clips securing it to the dash and pull out on the panel to
remove.
2. Pry up the piece of trim that looks like a vent in front of the instrument light cluster on top of the dash
using a panel removal tool to release and remove the trim.
3. Carefully pry out on the trim panel surrounding the heater controls using a panel removal tool to
release the fastening clips securing the trim to the dash and remove the trim.
4. Extract the three screws securing the bottom of the radio trim bezel to the dash.
5. Extract the three screws securing the front of the instrument light cluster to the top of the dash.
6. Extract the screw securing the back of the instrument light cluster to the dash, pry up on the light
cluster with a panel removal tool, unplug all connectors and remove.
7. Extract the three screws securing the top of the radio trim bezel to the dash on the drivers side of
the dash.
8. Pull the radio trim bezel away from the dash, unplug all connectors, shift the gear select lever into
low, tilt the steering wheel down and remove the bezel.
9. Extract the two screws securing the radio to the dash, pull the radio from the cavity, disconnect the
ground strap unplug all connectors and remove the radio.
#2190 Panel
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.
FOR DIN ISO AND SHAFT RADIO INSTALLATION, SEE PAGES 5 & 6.
Usar las pestañas sombreadas y los braquetes indicados. Cortar las pestañas restantes y descartarlas.
Para la instalación de radios DIN ISO y radios que se montan por los ejes, ver las páginas 5 y 6.
1996-00 Chrysler Town & Country
1996-00 Dodge Caravan
1996-00 Plymouth Voyager
Radio Removal:
1. Extract two screws in the trim bezel from just above the radio.
2. Pop off small trim below radio and extract (2) screws from behind.
3. Pull the radio trim bezel away from the dash, unplug the ac/heating control.
4. Extract the two screws securing the radio to the dash, pull the radio from the cavity, disconnect the
ground strap, unplug all connectors and remove the radio.
USE THESE SUPPORT
TABS AS REQUIRED
Usar tantas de estas
pestañas como sea
necesario
USE THIS BRACKET
Usar este braquete
"L" SPACER
Espaciador "L"
REMOVE ALIGNMENT PIN - BOTTOM
Sacar la clavija de alineamiento -
Inferior
"R" SPACER
Espaciador "R"
#2190 Panel
PRESS FIT ON ALIGNMENT 2 PLACES
Presionar para colocar alineamiento en 2 lugares
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.
FOR DIN ISO AND SHAFT RADIO INSTALLATION, SEE PAGES 5 & 6.
Usar las pestañas sombreadas y los braquetes indicados. Cortar las pestañas restantes y descartarlas.
Para la instalación de radios DIN ISO y radios que se montan por los ejes, ver las páginas 5 y 6.
USE THIS BRACKET
Usar este braquete
USE THESE SUPPORT TABS AS REQUIRED
Usar tantas de estas pestañas como sea
necesario
REMOVE ALIGNMENT
PIN - BOTTOM
Sacar la clavija de
alineamiento - Inferior
Read pages 2-6
for kit assembly.
Read pages 2-6
for kit assembly.