Owner's Manual

VEHICLE ASSEMBLY
@--------.--.
9. Connect the provided power
t-harness according to the diagram
displayed under the Test Connection
on page 5, or see illustration on the
right. Connect the female and male
12V power connectors first then
route the type-c connector to the
designated slot created during the
preparation steps on page 5.
10. Preform the following as listed, see
illustration 10 at right for referance:
A. Route the Type-C connector
through the hole created durring
preparation on the OEM panel.
8. Second, pass connection
through the CRQ04 beze.
Female Connector to
12V harness connector
• ~{=:}~ ♦
♦ S=JJ To Qi Module
Male Connector to (MQUSM)
Back of 12V Socket
0......-----~~---
C. Place direct-Qi bezel onto the
OEM pocket location.
11. Preform the following as listed, see @-i-..-: :::---~ ~----- ....
illustration 11 at right for referance:
A. Connect the Type-C connector
to the MQUSM.
8. Place the module onto Qi bezel
Notes:
• Hide any excess wiring under the panels
before reassembling.
• Use the provided two-sided adhesives to
secure the panel/module from moving.
12. Lastly, reassemble everything in
reverse order, then place your Qi
enabled device onto the CRQ04
assembly to charge your device.
Refer to LED Charging Status for
charging details (page 5).
*Phone NOT included
6