Owner's Manual

ManualsBrandsScosche ManualsApple & Android integrationPowerVolt™ Dash Port

Aegleter your product onllne

www.scosche.com/register

CPPDRLK-SP

USB Relocator

for

Apple

CarPlayfJ & Android Auto

with

Power

Delivery

IMPORTANT!

IJ " , uu

•i;

1 r

~~'~,?.:uR,:;~~

;.~1~?,~~1~

;~1

:~~u~~Jt"

~E'~

,.,

, ,.

,,,

HOURS

MON-FRI

8AM-5

30PM

(PST)

SATURDAY

8AM-2PM

(PST)

LIABILITY

DISCLAIMER

This Instruction manual

based

carefully documented

data

and research. Scosche Industries

Inc

. cannot

held responsible for discrepancies/inconsistencies that

may

occur

due

the

vehicle

manufacturing changes

options,

damages that

may

occur

In the vehicle during the Installation

components while using this manual.

you

have

any

further

questions

call

our

toll

free

techn

cal

help

llne

1-l!00-363-4490

vis

ooline

www.scosche.com/contact

SCOSCHE

INDUSTRIES, INC CPPDRLK-SP 06/21

Summary of content (4 pages)

PAGE 1
Aegleter your product onllne at www.scosche.com/register CPPDRLK-SP USB Relocator for Apple4D CarPlayfJ & Android Auto"" with Power Delivery " IMPORTANT! IJ ",uu 1r~~'~,?.:uR,:;~~-~. ;.~1~?,~~1~ ;~1:~~u~~Jt"l~E'~' ,., ,,.:,1,,, / ~ •i; HOURS MON-FRI 8AM-5 30PM (PST) SATURDAY 8AM-2PM (PST) LIABILITY DISCLAIMER This Instruction manual Is based on carefully documented data and research. Scosche Industries Inc.
PAGE 2
INSTALLATION 12V SOCKET REMOVAL INSTALLATION NOTE: These instructions are provided as a general guide and may differ from your particular vehicle. If you have difficulty removing the 12V lighter/ power socket in your vehicle, contact our tech support at (800) 363-4490 ext.1 . -------- Snap-in Type: 1. Use a panel removal tool (PRn to unsnap socket assembly (Figure 1). 2. Carefully slide out, unplug power connector and remove (Figure 2). Thread-in Type: 1.
PAGE 3
INSTALLATION I FIGURES Opened Protective Cover I Closed Protective Cover NOTE: Use of the protective (FIGURE 6) cover is recommended, particularly for marine applications. Install the cover prior to installing the CPPDRLK-SP plug into location. LOCKNUTS "" FIGURE 7 FIGURE I I LOCKNUTS INSTALLING THE CPPDRLK-SP 1. Remove the locknut from the CPPDRLK-SP housing (FIGURE 6). 2. Feed the connecting cable along the body of the unit through the 1"(26mm) diameter hole (FIGURE 7). 3.
PAGE 4
INSTALLATION i CONNECTING THE CPPDRLK-SP 1. Connect the USB Cable from the CPPDRLK-SP to the corresponding USB Input or dongle from the back of the stereo. 2. Connect the"+" Positive Male terminal from the back of the CPPDRLK-SP to a +12V Accessory Switched power source. (Socket replacement): Use the existing power lead from the previous power socket. (New Installation): Route a new power wire (not included) to a switched power source such as the vehicle's fuse bloclc. 3. Connect the .. _.