Owner's Manual
If you have any further questions, call our toll-free technical help line at:
SWC HARNESS
STEERINGWHEEL WIRING CONTROLS
FIGURE
2
SWC Wiring Diagram
"'
~
:;_:
___
_
Violet, Green, Orange Loops
¥~
i:,,
3
3
~
~
;,;
m
-<
"'
1.
Prepare SWC steering wheel connector harness by using the chart below
2. Connect the harness to the interface module.
3.
For Alpine, Clarion, JVC, Panasonic and Sony car stereos, connect the 3.5mm male steering plug
into the steering wheel input jack at the back
of
the stereo.
4. For Kenwood and newer JVC stereos, connect the BROWN wire from the steering wheel harness
to the
"Remote
in"
wire at the back
of
the stereo.
STEREO
BRAND
ALIPNE
CLARION
JVC
KENWOOD
PANASONIC
PIONEER/
SONY
OTHER BRANDS
Alpine
Sample 1
NOTE:
Cut
wire
only,
do
NOT
remove
Pioneer/
Sony
Sample
3
NOTE:
Do
NOT
cut
or
remove
wires
CONFIGURATION
CONNECTION
TO
STEREO
Cut Green Loop 3.5mm
Cut Violet Loop
3.5mm
Cut Green & Violet Loop 3.5mm or Brown (Key1)
Cut Orange & Green Brown (Key 1)
Cut Orange Brown (Key 1)
Do
Not Cut Loops 3.5mm
Call
Tech
Support Brown, Gray, Black
SAMPLE
Kenwood
Sample 2
NOTE:
Cut
wire
only,
do
NOT
remove
1-800-621-3695
x3
©2017
SCOSCHE INDUSTRIES, INC.
5
ITCLS0 1 B 10/17