User Guide

USER GUIDE
Page 2
Thank you for choosing Scorpion Backup Guard II. Please read this user’s manual carefully before you use
the product.
Safety Notice
Scorpion and its re-sellers are not responsible for your use of this product, or any damage or injuries you
may have caused or sustained from the usage.
• Charge Li-Po battery only on fireproof surface
• Do not exceed 3C charge rate
• Always monitor charging from start to finish
• Never short-circuit
• Never expose to fire or water
• Keep away from children and pets
• This is not a toy.
Limited Warranty
This limited warranty is twelve (12) months on electronic components from the date of original purchase.
This limited warranty applies only to manufacturing defects and does not apply to any improper installa-
tion, unauthorized repair, alteration, or modification of this product.
Included in the Bag
1 x Scorpion Backup Guard II (Power Board)
Features and Specifications
- Used as a stand-by power backup unit for hobby aircraft control systems (Receiver, Gyro, Servo …
etc.)
- Light weight: 10 grams (exclude battery)
- Dimension: 44 mm x 25.2 mm x 10.5 mm
- Li-Po requirement: 2S/7.4V, 500mAh - 1000mAh
- Output: DC 5V/10Amp Continues Current
- Charging Plug: JST-XHR
How does Scorpion Backup Guard II work?
When activated, the Scorpion Backup Guard II monitors whether that the BEC output voltage on the
helicopter or airplane is 5.5V or higher. If the Scorpion Backup Guard II detects a BEC failure has occurs, it
will take over and continue to power the radio system thus allow time for you to land your helicopter or
airplane safely.