Scorpion Backup Guard II v1.
USER GUIDE Thank you for choosing Scorpion Backup Guard II. Please read this user’s manual carefully before you use the product. Safety Notice Scorpion and its re-sellers are not responsible for your use of this product, or any damage or injuries you may have caused or sustained from the usage.
USER GUIDE LED Indicator Lights There are two sets of LED indicator lights on Scorpion Back Guard II. The colors of the LED lights indicate the status/condition of Scorpion Backup Guard II. To operate, the switch of Scorpion Backup Guard II has to be ON. LED Light # / Color Status / Condition Control systems are power ed by: LED 1 – RED Supplying Mode . 2S Battery 2S Li-Po battery is supplying power to control devices . Your BEC maybe at risk or have failed. LED 1 – GREEN Stand -by Monitoring Mode.
USER GUIDE Connect your Scorpion Backup Guard II Connect the DC 5V Output connector to an empty socket on the receiver. If all the sockets are being used, use a Y-harness wire to connect to any servo output socket. Warning: DO NOT plug the Scorpion Backup Guard II’s DC 5V Output connector into the S-Bus channel port. This will drain the Backup Guard II battery without charging.
