Installation manual

Setting Clock Time

1. Enter the programming mode.

2. Press button #4 repeatedly until the

icon begins to flash.

3. Press button #1 to select and enter clock setting mode.

4. Press button #1 to scroll through ‘hour’, ‘minute’, ‘am/pm’ settings. The selected item

will be flashing.

5. Press button #2 to adjust the setting of the selected item.

6. Press button #4 to save setting and exit, or press button #3 to abort.

Setting Alarm Clock

1. Enter the programming mode.

2. Press button #4 repeatedly until

icon begins to flash.

3. Press button #1 to select and enter alarm clock setting mode

4. Press button #1 to scroll through ‘alarm on/off’, ‘hour’, ‘minute’, ‘am/pm’ settings. The

selected item will be flashing.

5. Press button #2 to adjust the setting of the selected item.

6. Press button #4 to save setting and exit, or press button #3 to abort.

Encoding a Transceiver

Note: Transceivers are programmed from the factory. Encoding is only necessary should the

Transceiver loses its codes and will not arm or disarm the security system or if a second

or re

lacement remote is obtained.

1. Unplug HAR-1 from the MCM and plug it back in, the siren will chirp 2 times and the lights

will flash 2 times.

2. Within 6 seconds turn ignition switch “ON” and “OFF” 3 times.

3. If step 3 is done correctly and within the time allowed , the siren will chirp 2 times and

the lights will flash an additional 2 times to confirm that the system is in “Learn Mode”.

4. Press and hold button # 1 until the system chirps 2 times and the lights flash 2 times to

indicate that the MCM has learned the code.

5. The Transceiver echoes 4 chirps and the LCD displays [LErn donE] to confirm that the

Transceiver is encoded.

6. Turn ignition “ON” and “OFF” to exit “Learn Mode”.

This Section purposely left blank