User manual

IRD-2900 Series
Professional Integrated Receiver Decoders
Scopus Documents (p/n 100793) Page 3-19
• FREQUENCY BAND SCAN COMMAND:
The Frequency Band Scan Command allows scanning the selected
frequency range if the frequency is unknown. The symbol rate must be
known and set in the IRD. The IRD scan the frequency range, while
seeking a valid DVB stream. Upon locating a valid DVB stream, the IRD
marks the located frequency and service name. Results output either to
the RS-232 port (terminal) or Telnet. The following figure displays the
Frequency Band Scan Screen
NOTE
The IRD scans only the L-band frequency range. Located frequencies are shown in L-Band and must be modified
for the relevant frequency value if they are tuned to either C-band or Ku-band.
Frequency Band Scan
1 OFF
2{
ON
The available options are:
• OFF – Frequency scan is disabled
• ON – Frequency scan is enabled