User manual

User Manual
Installation
Page 2-8 (Rev. 2.0 /August 2005)
2.4.2. Powering Up
When powering up the IRD and the receiver is not tuned, expect one of the
following warnings:
• Front-End warning – Demodulator not sync
• Bit Stream warning – No sync – 0x47 detected
• Bit Stream warning – PSI not detected
In case the IRD warning led is lit orange, the operator must perform the
following:
• Tuning or configuring the IRD device
• Selecting a service from the input stream
When the IRD is correctly configured the display shows “All OK” and both LEDs
are lit green.
NOTE
Prior to initialization, review the IRD Front Panel Operation (see Chapter 3) for how to use and navigate through
the menus and for explanations of configuration parameters.
2.4.3. Tuning
The IRD receiver must be configured in order to receive a transport stream. For
details about an IRD device with a DVB-S receiver module, see Paragraph
3.3.1.1. For details about an IRD device with an MPEG-over-IP front-end
module, see Paragraph 3.3.1.2.
2.4.4. Selecting the Service
To select a service, see Paragraph 3.3.3.