User manual

User Manual
Overview
Page 1-10 (Rev. 2.0 /August 2005)
1.5.2.4. IRD-2963 Interfaces and Features
The IRD-2963 is a single 4:2:0 decoder IRD. All IRD-296X family consists of two
composite video interfaces. The CVBS #1 connector is used for broadcast quality
video and the CVBS #2 connector can be used for monitoring.
Figure 1-7 illustrates the IRD-2963 rear panel. The IRD-2963 basic features and
software-licensed features are described below.
Figure 1-7: IRD-2963 Rear Panel
Basic Features
•
2 composite video interfaces
• 2 SDI interfaces
• Embedded VBI and up to 2 stereo channels in SDI
•
2 analog-audio-stereo balanced interfaces
• 1
st
Active analog stereo pair
• 2
ND
Active analog stereo pair
•
2 AES/EBU-SPDIF audio-balanced interfaces
•
1
ST
and 2
ND
Active AES/EBU-SPDIF
• SNMP management (10/100 Base-T)
• Web-based management (10/100 Base-T)
•
RS-232 low speed data
• GPI
• Front panel monitoring connectors
Software-Licensed Features
•
ASI input
• Dual ASI output
• MPEG-over-IP output
•
IP data output (MPE de-capsulation)
• Genlock input and loop-through output
• Dolby Digital (AC-3) LT/RT downmixing
•
Linear PCM (SMPTE 302M 2000), Dolby-E
Pass-through
NOTE
This model requires a breakout cable to connect to the AES/EBU interfaces.
In the case of power failure or system shutdown, ASI OUT 1 output will become ASI loop-through. Use ASI OUT
1 output for cascading a chain of IRD-2900.