User manual

User Manual
Front Panel Operation
Page 3-58 (Rev. 2.0 /August 2005)
• LAYER FILTERING
The Layer Filtering parameter selects filtering mode to data.
Layer Filtering
1{ P.E.S PAYLOAD
2 T.S PAYLOAD
1{ T.S PACKET
The available options are:
• P.E.S Payload – Strips the header of the packetized elementary stream
(PES).
• T.S Payload – Strips the transport stream header (first 4 bytes out of
the 188 bytes packet)
• T.S Packet – Enables the entire transport stream packet (188 bytes)
3.3.6.3. IP-Out-Port Configuration Menu
NOTE
When selecting MPE mode you must verify that the MPE encapsulator setup is such that the MPEG packet
contains data of a single IP frame (for example, a single MPEG packet cannot contain data belonging to two
separate IP frames).
The IP-Out-Port Menu enables configuring the parameters of the IP-Out-Port.
The IP-Out-Port Menu is entered from the IRD Data Configuration Menu (see
Paragraph 3.3.6). The following figure displays the IP-Out-Port menu:
IP Out Port 1-2-6-2
1 Operational Mode MPEGoIP
2 Protocol UDP
3 IP Address 010.008.000.216
4
Network Mask 255.255.255.000
5 Default Gateway 010.008.000.001
6 Dest IP Address 010.013.100.003
7
UDP Source Port 02000
8 UDP Destination Port 02000
9 Num of Packets 07