User manual

Windows Server Program
ComTec GmbH 5-23
roi=1961 1988
roi=2909 2925
roi=2924 2943
roi=4036 4055
roi=2573 2590
The following commands perform actions and therefore usually are not included in a MPA3.CNF
file:
start ; Clears the data and starts a new acquisition. Further
; execution of the .CTL file is suspended until any
; acquisition stops due to a preset.
halt ; Stops acquisition if one is running.
cont ; Continues acquisition. If a time preset
; is already reached, the time preset
; is prolongated by the value which
; was valid when the „start„ command
; was executed. Further execution of
; the .CTL file is suspended (see start).
savecnf ; Writes the settings into MPA3.CNF
savempa ; Saves all configuration and spectra data.
; An existing file is overwritten.
pushname ; pushes the actual mpa filename on an internal stack that can hold 4
; names.
popname ; pops the last mpa filename from the internal stack.
loadmpa ; Loads mpa data; the filename
; must be specified before with a command mpaname=...
addmpa ; Adds mpa data to actual spectra; the filename
; must be specified before with a command mpaname=...
submpa ; Subtracts mpa data from actual spectra; the filename
; must be specified before with a command mpaname=...
erasempa ; Clears all spectra.
MPA ; Sets actual device to MPA for the following
; commands of the controlfile. (equivalent to ADC=0)
ADC=1 ; Sets actual ADC to ADC1 (=ADC1A, 2=ADC1B,..) for the
; following commands of the controlfile.
savedat ; Saves data of actual ADC as seperated
; spectrum (extension .MP) An existing file
; is overwritten.
loaddat ; Loads data of actual ADC, the filename
; must be specified before with a command datname=...
adddat ; Adds data into actual ADC spectra; the filename
; must be specified before with a command datname=...
subdat ; Subtracts data from actual ADC spectra; the filename
; must be specified before with a command datname=...
smooth ; Smoothes the data in actual ADC spectra