User manual

Windows Server Program
ComTec GmbH 5-19
The file MPA3.CNF contains a complete list of commands for setting parameters; an example is:
wndwidth=237 ; Sets width of server window
wndheight=263 ; Sets height of server window
loglevel=7 ; controls the logging of actions into the log file (hex format):
; bit 0 = 1 START, bit 1 = 1 STOP, bit 2 = 1 SAVE are
; protocoled with time into the logfile. (Default: loglevel=7)
loguse=0 ; use of log file:
; bit 0 = 1 ON, bit 1 = 1 ON at program start, bit 2 = 1 append
logfile=filename ; log file name
ctm=80 ; Coincidence time in units of 50 nsec.
; A value of 80 means 5 mikrosec
dtm=4000 ; Data Ready timeout in units of 50 nsec.
sen=0 ; Start coincidence window enable word (hex).
; Bit 0 means Start enable for ADC1A, Bit 1 for ADC1B...
coi=0 ; Coincidence enable word (hex)
; Bit 0 means Coinc. enable for ADC1A ...
aui=a003 ; AUX IN control word (hex)
; defines the use of AUX connectors for input:
; bit 0: AUX 2 polarity, 1 = active low
; bit 1: AUX 1 polarity, 1 = active low
; bit 2: AUX 2 start enable
; bit 3: AUX 1 start enable
; bit 4: AUX 2 coinc mode
; bit 5: AUX 1 coinc mode
; bit 12: /REJECT coinc mode
; bit 13: REJECT polarity, 1 = active low
; bit 15: Reject mode: 0 = instantly, 1 = at end of coinc. time
auo=0 ; AUX OUT control word (hex)
; defines the use of AUX connectors for output:
; bit 0..3 AUX 2 output multiplexer: 0 = coinc_start, 1 = coinc_run,
; 2 = coinc_active, 3 = coinc_ok, 4 = dead_store,
; 5 = enca, 6 = 1, 7 = 0
; bit 4..7 AUX 1 output multiplexer
; bit 8 AUX 2 output enable
; bit 9 AUX 1 output enable
; bit 10 AUX 2 mirror GO line (AUXMUX=7)
; bit 11 AUX 1 mirror GO line (AUXMUX=7)
dac=0 ; DAC value 0..255
diguse=0 ; Use of Digital I/O (hex):
; bit 0: DIG I/O bit 7 output status
; bit 1: Invert Polarity
; bit 2: Input bit 6 Trigger System
; bit 3: Clear before start triggered with DIG I/O bit 6
; bit 6: Output digval and increment digval after stop
; bit 7: Input Mode: =0 Resistive, =1 Tristate
; bit 8: Input Mode: =0 Pull-up, =1 Pull-down
digval=0 ; DIG I/O Output value
rtprena=0 ; Run time Preset enable
rtpreset=1000.000 ; Run time Preset value (seconds)