User manual

Installation Procedure
ComTec GmbH 2-13
Close Dualparameter and Calculated spectra and the MPANT display should show up with two
single spectra (ADC1A and ADC1B) and one multiparameter map (ref. Figure 2.18).
Connect input signals to the ADCs. In case of a pulser being the signal source split the pulser
output to both ADCs since only pulses that reach ADC1A and ADC1B within a 10µs time window
(the coincidence time) are counted. Actually in this case not coincident signals are also counted
Figure 2.17: New spectrum defined
Figure 2.18: Two single and one multiparameter spectra display