User manual

Installation Procedure
ComTec GmbH 2-7
Remove ADC1B, ADC1C and ADC1D from the Singles no coinc. by just clicking on them. If you
accidentally removed ADC1A bring it back to the Singles no coinc. field by selecting it with one
click and moving it by a click on >> below the Singles no coinc. box.
No we must set the range of the ADC to 1k. For this, open Options – Range, Preset... Change
the ADC Settings – Range to 1k = 1024 (ref. Figure 2.11) and click OK. The spectrum display of
ADC1 in the MPANT window changes to a full scale range of 1024 channels.
Be sure you connected an external pulse height analyzing ADC (set to 1k conversion gain) to the
ADC port A of module 1. Input analog signals to that ADC, e.g. from a pulser.
Figure 2.10: MPANT set to one SINGLE ADC