User manual

Installation Procedure
ComTec GmbH 2-1
2. Installation Procedure
2.1. Hard- and Software Requirements
The MPA-3 requires an IBM AT or compatible computer with an I486, Pentium or higher
processor and an available PCI slot. The computers power supply must be capable to provide
enough current (depending on the number of modules) from its 5V output to supply all connected
modules.
A Microsoft WINDOWS NT 4.0 or higher operating system must be installed.
2.2. Hardware Installation
Turn off the power to your computer system and remove the line cord. Discharge your body from
any static electricity by touching a grounded surface – e.g. the metal surface of the power supply
– before performing any further hardware procedure.
FAST ComTec assumes no liability for any damage, caused directly or indirectly, by improper
installation of any components by unqualified service personnel. If you do not feel comfortable
performing the installation, consult a qualified technician.
Damage to the MPA-3 system, the computer or injury to yourself may result if power is applied
during installation.
Figure 2.1: 16 port MPA-3 system