User`s manual

Schilling Marking Systems GmbH
In Grubenäcker 1 DE-78532 Tuttlingen
[phone] [phone]
[e-mail]
www.schilling-marking.de
MK3 - User’s Manual 51
Detailed operating instructions
5.18 Configuration
Commands used for configuration of the software are included in the ”Options” menu.
Fig. 23: Options menu
5.18.1 Changeover between design and working mode
As described above, the SchillMarker may be operated in two different modes. Changeover between
design and working mode is based on the ”Options” menu, with the active mode being ticked on the
menu.
5.18.2 Serial interface (COM port)
Owing to a PC only having 4 serial interfaces, the SchillMarker allows setting of the interface used.
Other serial transmission parameters, such as Baud rate, word length or parity checks are defaults set
by the controller of the Impact Marker and therefore do not require setting by the user of the
SchillMarker.
In order to change the COM port (= interface) for data transmission, select the ”COM-Port” command
in the ”Options” menu. The ”COM-Port” prompts window will be opened and displayed as follows:
Fig. 24: Prompts for selection of the COM port used