User`s manual

Schilling Marking Systems GmbH
In Grubenäcker 1 DE-78532 Tuttlingen
[phone] [phone]
[e-mail]
www.schilling-marking.de
MK3 - User’s Manual 17
Unpacking and installation
2.5.1 Ground connection
Connect the ground bolt of both the Control Unit and Marking Unit to a ground point, using a
cord of suitable section (not less than 10mm
2
) and headed with a plug.
2.5.2 Power connection
230
11
Using the supplied power socket connect the power cable and the plug; verify the setting on the
switch as indicated on the figure. Adjust using a screwdriver as required by the available a.c.
voltage.
Warning: The Controller is provided with power switch that feeds the power voltages to the
complete equipment.