User manual

3.4 CYLINDER PACK

1 Weight bracket 5 Carry handle with connecting pipe

2 Cylinder cover 6 Cylinder ring

3 Cylinder valve 7 Quick coupling for BCW/harness

4 Safety plug (23 mm open-ended wrench)

• The PED and DOT approved Divator Lite cylinder packs are available in two congurations. Divator

Lite 323.4 is a two-cylinder pack with two times 3.4 liters and 300 bar (75 cubic feet, 4350 psi) and Divator

Lite 326.7 is a two-cylinder pack with two times 6.7 liters and 300 bar (140 cubic feet, 4350 psi).

The cylinder pack consists of two cylinders assembled with two stainless steel tension ties. The cylinders

have a common valve mounted on one of the cylinders; the cylinders are then coupled via the connection

pipe that is protected by the carrying handle.

The Divator Lite cylinders are fully composite cylinders with plastic inserts that are wound with carbon

ber and ber glass.

To close the cylinder valve, the knob on the cylinder must be pressed in and subsequently turned. This

prevents unintentional closing of the valve.

The cylinder pack's safety disc is designed to break at a pressure of 450 ±50 bar (6525±725 psi).

Impacts against the cylinder pack can cause skewing and/or damage that weakens the unit. Skewing and

damage must be checked and rectied. Negligence when handling the cylinder with its weight tted may

result in deformation of the retaining pin or weight bracket.

Information about lling the cylinders can be found in Chapter 8 “Filling”.