Technical data

and help to maintain the integrity of the seals. Spare parts are

available by contacting Daystate or your local agent and

ordering the relevant parts.

Daystate Owners Club

The official owner’s club can be found on the Internet at:

www.daystate.com

. Log-on for all the latest information and

news.

Filling your air rifle with compressed air

1) Remove the dust cap from the front of the reservoir and

connect the female snap-on connector onto the inlet valve

whilst making sure that the outer sleeve is fully forward

and that the connection is secure.

2) Check that the bleed screw on the hose and gauge unit is

closed and slowly open the feed valve. Compressed air

will now fill the reservoir.

WRITE YOUR RIFLE’S DETAILS HERE:

3) Fill to the charging pressure indicated on the side of the

breech and then close the feed valve. Allow a few seconds

for the pressure to ‘settle’ and then top up if required.

4) Open the bleed valve on the hose and gauge unit and bleed

off the air from the filler hose.

5) Remove the snap-on connector and replace the dust cap.

Loading your rifle – Single Shot

Remember to keep the muzzle of the air rifle pointing in a safe

direction at all times.

1) Apply the safety catch*.

2) Lift the cocking handle at the rear of the breech block and

pull all the way back.

3) Check that the pellet is not damaged and place it in the

loading channel.

4) Push the cocking handle forward and make sure that the

handle is down.

THE AIR RIFLE IS NOW LOADED!

Disengage the safety catch and the rifle will now fire.