Technical data

25
switch to safe, the shot count is now programmed
STEP TURNING OFF THE SHOT COUNTER, STAGE 4
1
Pull the trigger, then switch the safety switch to FIRE, a red
light will be on
2 The gun will beep and the red light will blink
3 Keep trigger pulled until 4 beeps / blinks are given after 9s
4
Release trigger and the gun is now in programming mode
with the shot count reset to zero
5 Do not pull the trigger again to leave the shot count at zero
6 Set the safety switch to safe, the shot counter is off
STEP TURNING ON AND OFF THE MAG COUNTER, STAGE 5
1 Pull trigger, then switch safety to FIRE, a red light will be on
2
Keep trigger pulled until 5 beeps / blinks are given after 12s
and release the trigger
3
Pull the trigger to toggle between off/on, 1 beep and blink for
off, 2 beeps and blinks for on
4
Set the safety switch to safe, the magazine counter status is
programmed
STEP PROGRAMMING POWER SETTING, STAGE 6
1
Pull the trigger, then switch the safety switch to FIRE, a red
light will be on
2 Keep trigger pulled until 6 beeps / blinks are given after 15s
3
Release trigger and the gun is now in programming mode
with power set to maximum
4
Each time the trigger is pulled a beep and blink will indicate
that the power has been reduced by one step
5 Set the safety switch to safe, the power level is programmed
STEP RESETTING THE GUN TO DEFAULTS
1
Pull the trigger, then plug in the charger plug with the safety
switch in the safe position, a yellow light is on
2 Keep trigger pulled for three seconds until 7 beeps are given
3
Release trigger and the gun is in charging mode and
returned to default settings: magazine counter off, magazine
count set to zero, shot counter off, safety light normally on,
shot count set to zero and maximum power
26
Telescopic Rifle Sight Fitting and Zeroing Instructions:
Items required:
1) Two pieces of 35mm Film Negative
2) Sticky tape
3) Spirit level
4) Gun vice or ‘Workmate’ – This only applies to recoilless
rifles.
5) Plumb line set at a distance
Procedures Described:
1. Focusing
2. Attaching the mounts
3. Eye relief
4. Aligning the crosshair
5. Zeroing the rifle / scope combination.
Focusing:
At the rear of the scope there is a focus ring, point the scope at
a neutral object such as a light wall or the sky and rotate in and
out until the reticule is clear, if it has a locking ring lock it up
tight.
Attaching the mounts:
Daystate recommend the use of BKL 2-piece mounts. Loosely
fix one mount to the dovetails on the front section of the
breechblock and the other on the rear
Aligning the crosshair:
In this section you will be aligning the crosshair to the centre of
the bore.
You will need either the gun vice or ‘Workmate’ as to align the
sight the rifle will need to be held firmly and level.