Technical data

23
Pellet recommendations.
Daystate rifles and 10 shot magazines have been engineered for
longer pellets and may misalign or even jam if used with other
shorter brands. The use of Crosman Accupell for example, may
cause jamming and could invalidate the Daystate warranty.
In the UK, unlicensed rifles must not be capable of producing
power, with any projectile above the legal limit of 12
foot/pounds energy. The rifle has been set at the factory with
sufficient safety margin to ensure compliance with all currently
available pellets.
UK Test Pellets:
Harrier: Bisley Magnum
Mk3: Daystate FT
Recommended pellet types:
12 ft/lbs (UK unlicensed)
Daystate FT, JSB Exact, Air Arms Field, Bisley Magnum,
Beeman Kodiak.
Up to 25 ft/lbs:
Bisley Magnum, Beeman Kodiak, Daystate FT, JSB Exact, Air
Arms Field.
Up to 42 ft/lbs:
Bisley Magnum, Beeman Kodiak.
Over 42 ft/lbs:
.22 calibre: Eley Magnum.
24
CDT(b) Programming Quick Guide:
STEP RESETTING THE MAGAZINE COUNTER, STAGE 1
1
Pull the trigger, then switch the safety switch to FIRE, a red
light will be on
2 The gun will beep and the red light will blink,
3
Release the trigger, the magazine counter is reset and the
gun is now ready for firing
STEP
RESETTING THE SHOT COUNTER, STAGE 2
1
Pull the trigger, then switch the safety switch to FIRE, a red
light will be on
2 The gun will beep and the red light will blink
3
Keep trigger pulled for 3 seconds until a double beep and
blink is given after 3s
4
Release the trigger, the shot counter is now reset and the
gun is ready for firing
STEP TURNING ON AND OFF THE SAFETY LIGHT, STAGE 3
1
Pull the trigger, then switch the safety switch to FIRE, a red
light will be on
2
Keep trigger pulled until 3 beeps and blinks are given after
6s and release the trigger
3
Pull the trigger to toggle between normally off/on, 1 beep
and blink for off, 2 beeps and blinks for on.
4
Set the safety switch to safe, the safety light status is
programmed
STEP PROGRAMMING THE SHOT COUNTER, STAGE 4
1
Pull the trigger, then switch the safety switch to FIRE, a red
light will be on
2 The gun will beep and the red light will blink
3 Keep trigger pulled until 4 beeps / blinks are given after 9s
4
Release trigger and the gun is now in programming mode
with the shot count reset to zero
5
Each time the trigger is pulled a beep and blink will indicate
that the shot counter is increased by 10
6
When the required shot count is reached, set the safety