Instruction manual

Disassemble one ring and reassemble over the scope body between the turret and
the eyepiece so that the clamp nut (D-73) is positioned to the right of the scope.
Install the four top screws. Do not tighten.
Disassemble the other ring and install it on the forward section of the scope tube
with the clamp nut positioned to the right of the scope. Install the four top
screws. Again, do not tighten.
Assemble the rings to the scope base with the locating “tabs” engaging the
recesses in the top surface of the base. Tighten the clamp nuts so that the rings
are locked to the semi-circular cuts on the sides of the scope base. Rotate the
scope until cross-hairs are aligned properly, and slide scope to desired eye relief.
Then tighten the eight top screws a bit at a time to grip the scope body. Sight in
according to the directions with your scope.
SERVICE AND PARTS POLICY
If you have any questions with regard to the performance of your RUGER
®
MARK II pistol, please call (928-778-6555) or write our Prescott, Arizona
Product Service Department, fully describing all circumstances and conditions
involved. If you should return your pistol to the factory for repair, or order parts
for it, please comply with the following suggestions for prompt service:
29
SHIPPING FIREARMS FOR REPAIR
RUGER
®
MARK II pistols returned to the factory for services or repair
should be sent to: Sturm Ruger & Co., Inc., Product Service Department, 200
Ruger Road, Prescott, AZ 86301-6181. Telephone: [phone].
Guns should be sent prepaid. W
e will not accept collect shipments.
The Federal Gun Control Act, as well as the laws of most States and localities, do
not prohibit an individual (who is not otherwise barred from purchasing or
possessing a firearm) from shipping a firearm directly to the manufacturer for
repair. However, before you ship your firearm to us, be certain that your State or
locality does not have a law or regulation which will prohibit you from receiving
it from us after it has been repaired. If such receiving is prohibited, then please
have a Federally Licensed firearms dealer ship the gun to us. If it is sent to us by
a dealer, it will be returned to him after being repaired. If a handgun (pistol or
revolver) is shipped by an individual who does not hold a Federal Firearms
License, it must
be shipped via U.P.S. (Next Day Air) Persons who do not hold a
Federal Firearms License are prohibited by Federal law from shipping a handgun
by Mail. Handguns mailed in violation of the law are impounded by the Post
Office.
Please do not include holster, custom grip panels, or custom accessories with a
firearm being shipped to the factory for service. DO NOT SEND GUN BOXES
OR LITERATURE THAT YOU CONSIDER TO BE COLLECTOR’S ITEMS -
THESE ARE INVARIABLY DAMAGED OR DESTROYED IN SHIPMENT.
Always insure your shipment.
WARNING: BEFORE SHIPPING ANY FIREARM,
BE ABSOLUTELY CERTAIN THAT IT AND ITS MAGAZINES
ARE UNLOADED. DO NOT SHIP CARTRIDGES WITH A
FIREARM.