Instruction manual

Using a paper clip or similar non-marring tool, pull down on the main spring

housing latch located at the lower rear of the pistol grip. Swing the main spring

housing upward. With the pistol pointed upward, pull the trigger. Keeping the

pistol pointing downward swing the main spring housing back in to the pistol

grip and push the latch back into the main spring housing until it is flush with

the pistol grip.

When assembled in this manner, it should be impossible to fully retract the bolt

to chamber a cartridge. With the muzzle pointed in a safe direction, test the

pistol by attempting to retract the bolt. If the bolt cannot be retracted more than

a fraction of an inch, the pistol has been assembled in an inoperative condition.

It is uncocked and cannot be fired without correct reassembly.

To reassemble the pistol for firing, again using a paper clip or similar non-

marring tool, pull down on the main spring housing latch and point the muzzle

upward. Pull the trigger and keep the muzzle pointed in an upward direction.

Swing the main spring housing back into position and shut the main spring

housing latch. Test the pistol to be sure it is correctly reassembled by attempting

to retract the bolt fully. If the bolt can be fully retracted, the pistol is correctly

reassembled and can be loaded and fired normally.

While the pistol is less likely to be used by unauthorized persons when

assembled in the above inoperative manner, it is always safest to store the

pistol with the supplied locking device correctly installed on the pistol, or to

store the pistol in a gun safe or other secure location away from children or

unauthorized adults. Guns should always be stored securely, unloaded

and

separate from their ammunition.

Never place or store any firearm in

such a manner that it may be

dislodged. Firearms should always be

stored securely and unloaded, away

from children and careless adults. Use

the locking device originally supplied

with this firearm for storage.

The use of a locking device or safety

lock is only one aspect of responsible

firearms storage. For increased safety,

firearms should be stored unloaded

and locked in a location that is both

separate from their ammunition and

inaccessible to children and any other

unauthorized person.

STORE SECURELY &

UNLOADED

WARNING –STORAGE