Instruction manual

STORAGE
GUNS SHOULD NOT BE STORED LOADED!
Do not keep the pistol stored in a leather holster or case. Leather attracts
moisture, even though the holster or case may appear to be perfectly dry.
TO RENDER THE PISTOL INOPERATIVE FOR SAFE STORAGE
With the muzzle pointed in a safe direction, remove the magazine, retract the
bolt, and check the chamber to be sur
e the pistol is completely unloaded! Now
close the bolt and carefully pull the trigger to un-cock the pistol.
Firing a pistol with oil, grease, or any other
material even partially obstructing the bore
may result in damage to the pistol and
serious injury to the shooter and those
nearby.
Do not spray or apply lubricants directly on
ammunition. If the powder of a cartridge is
affected by the lubricant, it may not be
ignited, but the primer firing may push the
bullet into the bore where it may become
lodged. Firing a subsequent bullet into the
obstructed bore may damage the pistol and
cause serious injury or death to the shooter
and those nearby. Use lubricants properly.
You are responsible for the proper care and
maintenance of your firearms.
3. Using powder solvent on a clean patch or bristle brush, remove powder
residue from all components of the mechanism. After cleaning, run a dry
patch through the bore, then follow with a patch that is very lightly oiled.
Wipe all surfaces clean with a cloth, then wipe all surfaces with a patch or
cloth that has been very lightly oiled.
4. NOTE: Only a light application of oil is needed to provide adequate
lubrication of moving parts and to prevent rust. Excess accumulations of oil
tend to attract particles of dust and dirt and may congeal in cold weather
which can interfere with the safe and reliable function of the pistol.
5. If magazine becomes dirty, it should be disassembled and thoroughly cleaned
(See “Magazine Disassembly” section, p. 24).
6. Before firing remove all oil and grease from the bore.
26
WARNING –LUBRICATION
IMPROPER LUBRICATION
DESTROYS GUNS
USE THE LOCKING DEVICE SUPPLIED WITH THE PISTOL FOR STORAGE.
(SEE PAGE 6)